Chapter 20 Maintenance
EMG2306-R10A User’s Guide
144
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default EMG2306-
R10A IP address (192.168.1.2). See Appendix C on page 176 for details on how to
set up your computer’s IP address.
20.8 Restart Screen
System restart allows you to reboot the EMG2306-R10A without turning the power off.
Click Maintenance > Restart to open the following screen.
Figure 90 Maintenance > Restart
Click Restart to have the EMG2306-R10A reboot. This does not affect the EMG2306-R10A's
configuration.
20.9 Language
Use this screen to change the language for the Web Configurator.
Select the language you prefer and click Apply. The Web Configurator language changes after a
while without restarting the EMG2306-R10A.
Upload Click Upload to begin the upload process.
Note: Do not turn off the EMG2306-R10A while configuration file upload is in progress.
After you see a “configuration upload successful” screen, you must then wait one minute
before logging into the EMG2306-R10A again. The EMG2306-R10A automatically restarts in
this time causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Reset
Pressing the Reset button in this section clears all user-entered configuration
information and returns the EMG2306-R10A to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
EMG2306-R10A. Refer to the chapter about introducing the Web Configurator for more
information on the RESET button.
Table 63 Maintenance > Backup/Restore (continued)
LABEL DESCRIPTION
To Next Page
Loading...
