Chapter 9 Wireless LAN
EMG2306-R10A User’s Guide
76
Note: If you do not enable any wireless security on your EMG2306-R10A, your network is
accessible to any wireless network device that is within range.
Figure 33 Wireless LAN > General: Security: No Security
The following table describes the labels in this screen.
9.5.2 WEP Encryption
WEP encryption scrambles the data transmitted between the wireless stations and the access points
to keep network communications private. It encrypts unicast and multicast communications in a
network. Both the wireless stations and the access points must use the same WEP key.
Your EMG2306-R10A allows you to configure up to four 64-bit or 128-bit WEP keys but only one key
can be enabled at any one time.
Table 23 Wireless LAN > General: Security: No Security
LABEL DESCRIPTION
Security Mode Choose No Security from the drop-down list box.
Apply Click Apply to save your changes back to the EMG2306-R10A.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
Need help?
General
