EMG2306-R10A User’s Guide 122
CHAPTER 18
Remote Management
18.1 Overview
This chapter provides information on the Remote Management screens.
Remote Management allows you to manage your EMG2306-R10A from a remote location through
the following interfaces:
•LAN and WAN
•LAN only
Note: The EMG2306-R10A is managed using the Web Configurator.
18.2 What You Need to Know
Remote management over LAN or WAN will not work when:
1 The IP address in the Secured Client IP Address field (Section 18.4 on page 123) does not match
the client IP address. If it does not match, the EMG2306-R10A will disconnect the session
immediately.
2 There is already another remote management session. You may only have one remote
management session running at one time.
3 There is a firewall rule that blocks it.
18.2.1 Remote Management and NAT
When NAT is enabled:
• Use the EMG2306-R10A’s WAN IP address when configuring from the WAN.
• Use the EMG2306-R10A’s LAN IP address when configuring from the LAN.
18.3 What You Can Do
•Use the WWW screen to configure through which interface(s) and from which IP address(es)
users can use HTTP or HTTPs to manage the NBG4104 (Section 18.4 on page 123).
•Use the Telnet screen to configure through which interface(s) and from which IP address(es)
users can use Telnet to manage the EMG2306-R10A (Section 18.5 on page 123).
To Next Page
Loading...
Need help?
General
