EMG2306-R10A User’s Guide 107
CHAPTER 14
Static Route
14.1 Overview
This chapter shows you how to configure static routes for your EMG2306-R10A.
Each remote node specifies only the network to which the gateway is directly connected, and the
EMG2306-R10A has no knowledge of the networks beyond. For instance, the EMG2306-R10A
knows about network N2 in the following figure through remote node Router 1. However, the
EMG2306-R10A is unable to route a packet to network N3 because it doesn't know that there is a
route through the same remote node Router 1 (via gateway Router 2). The static routes are for you
to tell the EMG2306-R10A about the networks beyond the remote nodes.
Figure 58 Example of Static Routing Topology
14.2 Static Route Screen
Click Configuration > Network > Static Route to open the Static Route screen.
Figure 59 Configuration > Network > Static Route > Static Route