EMG2306-R10A User’s Guide 105
CHAPTER 13
DDNS
13.1 Overview
Dynamic Domain Name Service (DDNS) services let you use a fixed domain name with a dynamic
IP address. Users can always use the same domain name instead of a different dynamic IP address
that changes each time to connect to the EMG2306-R10A or a server in your network.
Note: The EMG2306-R10A must have a public global IP address and you should have your
registered DDNS account information on hand.
13.2 The DDNS General Screen
To change your EMG2306-R10A’s DDNS, click Configuration > Network > DDNS. The General
screen appears as shown.
Figure 57 Configuration > Network > Dynamic DNS > Dynamic DNS
The following table describes the labels in this screen.
Table 44 Configuration > Network > Dynamic DNS > Dynamic DNS
LABEL DESCRIPTION
Dynamic DNS Setup
Dynamic DNS Select Enable to use dynamic DNS.
Service Provider Select the name of your Dynamic DNS service provider.
Host Name The host name is the domain name that the DDNS service will map to your dynamic
global IP address. Type the host name fully qualified, for example,
‘yourhost.mydomain.net’. You can specify up to two host names in the field separated
by a comma (",").
User Name Type the user name that you used when you registered with the DDNS service.
Password Type the password associated with the DDNS user name.
To Next Page
Loading...
Need help?
General
