Chapter 18 Remote Management
EMG2306-R10A User’s Guide
127
18.7 The TR069 Screen
TR-069 defines how Customer Premise Equipment (CPE), for example your ZyXEL Device, can be
managed over the WAN by an Auto Configuration Server (ACS). TR-069 is based on sending
Remote Procedure Calls (RPCs) between an ACS and a client device. RPCs are sent in Extensible
Markup Language (XML) format over HTTP or HTTPS.
An administrator can use an ACS to remotely set up the EMG2306-R10A, modify settings, perform
firmware upgrades as well as monitor and diagnose the EMG2306-R10A. You have to enable the
device to be managed by the ACS and specify the ACS IP address or domain name and username
and password.
Click Configuration > Management > Remote MGMT > TR069 to display the screen as shown.
Use this screen to configure your EMG2306-R10A to be managed by an ACS.
Figure 71 Configuration > Management > Remote MGMT > TR069
The following table describes the labels in this screen.
Trap Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.
Table 54 Configuration > Management > Remote MGMT > SNMP (continued)
LABEL DESCRIPTION
Table 55 Configuration > Management > Remote MGMT > TR069
LABEL DESCRIPTION
Inform Select Enable for the EMG2306-R10A to send periodic inform via TR-069 on the WAN.
Otherwise, select Disable.
Inform Interval Enter the time interval (in seconds) at which the EMG2306-R10A sends information to
the auto-configuration server.
ACS URL Enter the URL or IP address of the auto-configuration server.
ACS Username Enter the TR-069 user name for authentication with the auto-configuration server.
To Next Page
Loading...
