Chapter 18 Remote Management
EMG2306-R10A User’s Guide
126
To change your EMG2306-R10A’s SNMP settings, click Configuration > Management > Remote
MGMT > SNMP to display the screen as shown.
Figure 70 Configuration > Management > Remote MGMT > SNMP
The following table describes the labels in this screen.
Table 54 Configuration > Management > Remote MGMT > SNMP
LABEL DESCRIPTION
SNMP Settings
Server Port The SNMP agent listens on port 161 by default. If you change the SNMP server port to a
different number on the EMG2306-R10A, for example 8161, then you must notify
people who need to access the EMG2306-R10A SNMP agent to use the same port.
Server Access Select the interface(s) through which a computer may access the EMG2306-R10A using
this service.
Secured Ip Select All to allow all computers to access the EMG2306-R10A.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG2306-R10A.
SNMP Enable Select this to enable SNMP on this device.
Get Community Enter the SNMP get community information here.
Set Community Enter the SNMP set community information here.
System Location Enter the SNMP system location.
System Contact Enter the SNMP system contact.
Trap Settings
Trap Enable Select this to enable trap settings on this device.
Trap Manager IP Type the IP address of the station to send your SNMP traps to.
To Next Page
Loading...
Need help?
General
