Chapter 9 Wireless LAN
EMG2306-R10A User’s Guide
83
9.8 Wireless LAN Advanced Screen
Use this screen to allow wireless advanced features, such as the output power, RTS/CTS Threshold
and high-throughput physical mode settings.
Click Configuration > Network > Wireless LAN > Advanced. The screen appears as shown.
Figure 39 Configuration > Network > Wireless LAN > Advanced
The following table describes the labels in this screen.
Apply Click Apply to save your changes back to the EMG2306-R10A.
Cancel Click Cancel to exit this screen without saving.
Table 28 Configuration > Network > Wireless LAN > MAC Filter (continued)
LABEL DESCRIPTION
Table 29 Configuration > Network > Wireless LAN > Advanced
LABEL DESCRIPTION
Wireless Advanced Setup
RTS/CTS Threshold Data with its frame size larger than this value will perform the RTS (Request To Send)/
CTS (Clear To Send) handshake.
Enter a value between 256 and 2432.
Fragmentation
Threshold
The threshold (number of bytes) for the fragmentation boundary for directed messages.
It is the maximum data fragment size that can be sent. Enter an even number between
256 and 2346.
Intra-BSS Traffic A Basic Service Set (BSS) exists when all communications between wireless clients or
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is
enabled, wireless client A and B can access the wired network and communicate with
each other. When Intra-BSS is disabled, wireless client A and B can still access the
wired network but cannot communicate with each other.
Tx Power Set the Tx power of the EMG2306-R10A in this field. If there is a high density of APs in
an area, decrease the output power of the EMG2306-R10A to reduce interference with
other APs. Select one of the following 100%, 90%, 75%, 50%, 25% or 10%. See
the product specifications for more information on your EMG2306-R10A’s output power.
Apply Click Apply to save your changes back to the EMG2306-R10A.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
Need help?
General
