Chapter 20 Maintenance
EMG2306-R10A User’s Guide
140
20.5 Time Setting Screen
Use this screen to configure the EMG2306-R10A’s time based on your local time zone. To change
your EMG2306-R10A’s time and date, click Maintenance > Time. The screen appears as shown.
Figure 86 Maintenance > Time
The following table describes the labels in this screen.
Table 61 Maintenance > Time
LABEL DESCRIPTION
Current Time and Date
Current Time This field displays the time of your EMG2306-R10A.
Each time you reload this page, the EMG2306-R10A synchronizes the time with the time
server.
Current Date This field displays the date of your EMG2306-R10A.
Each time you reload this page, the EMG2306-R10A synchronizes the date with the time
server.
Current Time and Date Setup
Manual Select this radio button to enter the time and date manually. If you configure a new time
and date, Time Zone and Daylight Saving at the same time, the new time and date you
entered has priority and the Time Zone and Daylight Saving settings do not affect it.
New Time
(hh:mm:ss)
This field displays the last updated time from the time server or the last time configured
manually.
When you select Manual, enter the new time in this field and then click Apply.
To Next Page
Loading...
