Chapter 10 LAN
EMG2306-R10A User’s Guide
91
10.4 LAN IP Screen
Use this screen to change the IP address for your EMG2306-R10A. Click Configuration >
Network > LAN > IP.
Figure 47 Configuration > Network > LAN > IP
The following table describes the labels in this screen.
10.5 IP Alias Screen
Use this screen to have the EMG2306-R10A apply IP alias to create LAN subnets. Click
Configuration > Network > LAN > IP Alias.
Figure 48 Configuration > Network > LAN > IP Alias
Table 35 Configuration > Network > LAN > IP
LABEL DESCRIPTION
IP Address Type the IP address of your EMG2306-R10A in dotted decimal notation.
IP Subnet Mask The subnet mask specifies the network number portion of an IP address. Your
EMG2306-R10A will automatically calculate the subnet mask based on the IP address
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the EMG2306-R10A.
Apply Click Apply to save your changes back to the EMG2306-R10A.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
