EMG2306-R10A User’s Guide 93
CHAPTER 11
DHCP Server
11.1 Overview
Dynamic Host Configuration Protocol (DHCP), RFC 2131 and RFC 2132 allow individual clients to
obtain TCP/IP configuration at start-up from a server. You can configure the EMG2306-R10A’s LAN
as a DHCP server or disable it. When configured as a server, the EMG2306-R10A provides the TCP/
IP configuration for the clients. If DHCP service is disabled, you must have another DHCP server on
your LAN, or else the computer must be manually configured.
11.2 What You Can Do
•Use the General screen to enable the DHCP server (Section 11.4 on page 94).
•Use the Advanced screen to assign IP addresses on the LAN to specific individual computers
based on their MAC Addresses (Section 11.5 on page 95).
•Use the Client List screen to view DHCP client list (Section 11.6 on page 96).
11.3 What You Need To Know
The following terms and concepts may help as you read through this chapter.
MAC Addresses
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address is
assigned at the factory and consists of six pairs of hexadecimal characters, for example,
00:A0:C5:00:00:02. Find out the MAC addresses of your network devices if you intend to add them
to the DHCP Client List screen.
To Next Page
Loading...
Need help?
General
