Chapter 8 WAN
EMG2306-R10A User’s Guide
69
The following table describes the labels in this screen.
Table 20 Configuration > Network > WAN > Advanced
LABEL DESCRIPTION
Multicast Setup
Multicast Setup Select IGMPv1/v2 to enable multicasting. This applies to traffic routed from the WAN
to the LAN.
Select None to disable this feature. This may cause incoming traffic to be dropped or
sent to all connected network devices.
Auto-Subnet Configuration
Enable Auto-IP-
Change Mode
Select this option to have the EMG2306-R10A switch to bridge mode automatically
when the EMG2306-R10A gets a WAN IP address in the range of 192.168.x.y (where x
and y are from zero to nine) no matter what the LAN IP address is.
Apply Click Apply to save your changes back to the EMG2306-R10A.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
Need help?
General
