Chapter 20 Maintenance
EMG2306-R10A User’s Guide
147
Note: If you select the incorrect System Operation Mode you may not be able to connect
to the Internet.
Access Point Select Access Point Mode if your device bridges traffic between clients on the same
network.
•In Access Point Mode, all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port labeled WAN.
There is no WAN port.
• The DHCP server on your device is disabled.
• The IP address of the device on the local network is set to 192.168.1.2.
Apply Click Apply to save your settings.
Cancel Click Cancel to exit this screen without saving.
Table 64 Maintenance > Sys OP Mode (continued)
LABEL DESCRIPTION
To Next Page
Loading...
