Chapter 21 Troubleshooting
EMG2306-R10A User’s Guide
150
2 Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
Start Guide.
3 Make sure your Internet browser does not block pop-up windows and has JavaScript and Java
enabled. See Appendix A on page 155.
4 Make sure your computer is in the same subnet as the EMG2306-R10A. (If you know that there are
routers between your computer and the EMG2306-R10A, skip this step.)
• If there is a DHCP server on your network, make sure your computer is using a dynamic IP
address. See Section 10.4 on page 91.
• If there is no DHCP server on your network, make sure your computer’s IP address is in the
same subnet as the EMG2306-R10A. See Section 10.4 on page 91.
5 Reset the device to its factory defaults, and try to access the EMG2306-R10A with the default IP
address. See Section 2.4 on page 18.
6 If the problem continues, contact the network administrator or vendor, or try one of the advanced
suggestions.
Advanced Suggestions
• Try to access the EMG2306-R10A using another service, such as Telnet. If you can access the
EMG2306-R10A, check the remote management settings and firewall rules to find out why the
EMG2306-R10A does not respond to HTTP.
• If your computer is connected to the WAN port or is connected wirelessly, use a computer that is
connected to a LAN/ETHERNET port.
I can see the Login screen, but I cannot log in to the EMG2306-R10A.
1 Make sure you have entered the password correctly. The default password is 1234. This field is
case-sensitive, so make sure [Caps Lock] is not on.
2 You cannot log in to the Web Configurator while someone is using Telnet to access the EMG2306-
R10A. Log out of the EMG2306-R10A in the other session, or ask the person who is logged in to log
out.
3 This can happen when you fail to log out properly from your last session. Try logging in again after
5 minutes.
4 Disconnect and re-connect the power adaptor or cord to the EMG2306-R10A.
5 If this does not work, you have to reset the device to its factory defaults. See Section 21.5 on page
152.
To Next Page
Loading...
Need help?
General
