Aanderaa ZPulse DCS 4420 - Factory Configuration

Page 18 February 2020 – TD 266 OPERATING MANUAL – ZPulse® DCS 4420/4830/4520/4930
1.7.1 Factory Configuration
All properties in this section are Read Only, not possible to overwrite for the user. Only certified Aanderaa service
personal can alter these settings. The access level for reading the status of this properties are however different for
each property, see table for more details. In this group we find information about Software and hardware settings,
Production, Service and Calibration dates.
Table 1-5: Sensor properties for Doppler Current Profiler Sensor 4420/4420R, 4520/4520R, 4830/4830R and 4930/4930R.
ENUM=Enumeration, INT =Integer, BOOL=Boolean (‘yes’/’no’)
Property Type
No of elements
Use
Configuration Category
Access
Protection
Read/Write
Product Name String 31 AADI Product name, default Doppler Current Sensor
FC
No /
Read
Only
Product Number String 6
AADI Product number, default 4420, 4420R, 4520, 4520R,
4830, 4830R, 4930 and 4930R
Serial Number INT 1 Serial Number
SW ID String 11 Unique identifier for internal firmware
SW Version INT 3 Software version (Major, Minor, Built)
HW ID X String 19 Hardware Identifier, X =1..3
1)
unique identifier for hardware
High /
Read
Only
HW Version X String 9 Hardware Identifier, X =1..3
1)
(Rev. x)
System Control INT 3 For AADI service personnel only
Production Date String 31
AADI production date, format YYYY-MM-DD (Not in use)
Last Service String 31
Last service date, format YYYY-MM-DD, empty by default
Last Calibration String 31
Last calibration date, format YYYY-MM-DD (Not in use)
Calibration Interval INT 1
Recommended calibration interval in days (Not in use)
1)
Hardware ID 1 is Analog Board for Transducer 1 and 2. Hardware ID 2 is Analog Board for Transducer 3 and 4 and
Hardware ID 3 is for Digital Board