February 2020 – TD 266 OPERATING MANUAL – ZPulse® DCS 4420/4830/4520/4930 Page 33
2.5 System Configuration
The System Configuration is
separated in 5 groups. The
settings in these groups are
mainly used to configure the
sensor.
Refer chapter 1.7.3 for more
information on the properties in
System Configuration.
If you change mode you might
need to go back to the Recorder
panel and Refresh Status and
or Stop Recorder before you
can continue to configure.
The Mode setting will also
influence some of the
alternatives in the rest of the
session.
For more information on each
property see chapter 2.5.1 to
2.5.5.
Figure 2-15: System Configuration
To Next Page
Loading...