Aanderaa ZPulse DCS 4420 User Manual

Page 58 February 2020 – TD 266 OPERATING MANUAL – ZPulse® DCS 4420/4830/4520/4930
3.12 System Configuration
Select System Configuration
under Device Configuration (refer
Figure 3-20 and Figure 3-21).The
different sensors connected to the
same Datalogger will show up as
selectable items, Refer Figure
3-25.
Double-click on the DCS to start
configure
Note that this menu is dependent
on the SGII and SmG Feature
setting under User Mainenance.
If Enable Sensor Parameter Input
is enabled then an additional group
called Input Parameter Compass
will show up.
Figure 3-25: System configuration
Input Parameter Compass is only available in AiCaP mode and only when used with SeaGuardII or SmartGuard. This
setting is used to read an external compass. If the internal compass is disturbed by any magnetic influence this can be
useful to correct for this deviation.

Aanderaa ZPulse DCS 4420 Specifications

General

Brand	Aanderaa
Model	ZPulse DCS 4420
Category	Accessories
Language	English