Aanderaa ZPulse DCS 4420 - Deployment Settings

February 2020 – TD 266 OPERATING MANUAL – ZPulse® DCS 4420/4830/4520/4930 Page 19
1.7.2 Deployment Settings
Deployment Settings contains settings interval and for instruments metadata like location and position.
Table 1-6: Sensor properties for Doppler Current Sensor 4420/4420R, 4520/4520R, 4830/4830R and 4930/4930R
ENUM=Enumeration, INT =Integer, BOOL=Boolean (‘yes’/’no’)
Property Type
No of elements
Use
Configuration Category
Access
Protection
Read/Write
Interval ENUM 1
Set the output interval in seconds.. Minimum available interval is
dependent on configuration (time to do all ping
measurements).
1)
DS
No /
No
2)
Location
String
31
User setting for location
No /
No
Geographic Position String 31 User setting for geographic position
Vertical Position String 31
User setting for describing sensors vertical position/depth
Reference String 31
User setting for describing sensor reference, user definable.
1)
The interval is an enumerated type. The enumerated value for the Interval is shown when sending a Help command to
the sensor.
2)
Only available for stand-alone use. Not visible in AiCaP mode.