February 2020 – TD 266 OPERATING MANUAL – ZPulse® DCS 4420/4830/4520/4930 Page 53
3.8 Changing Values
To change the content of a property first
tick in the value box of the actual
property and then enter the text or
number before pressing Next.
See example in Figure 3-16 where the
text for Location has been changed.
The value is not changed before you
have finished the full process. If you
press Cancel the changes will not be
stored.
Figure 3-16 Change value
In the next picture a list of all properties
that has been changed will show up.
If the list of configuration changes is
correct press Next to start the update
process.
Figure 3-17: Confirm Configuration Changes
To Next Page
Loading...