Page 56 February 2020 – TD 266 OPERATING MANUAL – ZPulse® DCS 4420/4830/4520/4930
3.11 Deployment settings
Under Device Configuration (refer
Figure 3-20 and Figure 3-21).Select
Deployment Settings. Double-click
on the DCS to select the Doppler
current sensor (refer Figure 3-22)
If additional sensors are connected to
the SeaGuardII platform or
SmartGuard it is possible to configure
the DCS to take input from an
external compass.
Figure 3-22: Deployment settings
.
The Deployment Settings holds only
one group. The settings in this group
are mainly used as information.
Figure 3-23: Deployment Settings DCS
To Next Page
Loading...
Need help?
General