Aanderaa ZPulse DCS 4420 - Configuration with Real-Time Collector; Connected Via Seaguardii; Connected Via Smartguard; Connected Via Seaguard with Plug Assembly 5561

February 2020 – TD 266 OPERATING MANUAL – ZPulse® DCS 4420/4830/4520/4930 Page 45
3.3 Configuration with Real-Time collector
To establish connection between the Instrument and AADI Real-Time collector you need to decide how to connect. If
you are using a USB connection follow the instructions in chapter 3.4.1, USB is the most used connection for
SeaGuardII and SmartGuard. If you are using a serial connection follow the instruction in chapter 3.4.2, this connection
is most used with SeaGuard including plug assembly and Real-Time connected instruments. If you want to use the
touch screen (only available with SeaGuard) then jump to CHAPTER 5.
3.3.1 Connected via SeaGuardII
• Connect the micro USB configuration cable between the USB connector in front of the instrument and to the PC
• Install and start the AADI Real-Time Collector software on your PC (provided on the Memory stick delivered
with the instrument if ordered). For more information about the AADI Real-Time Collector, refer TD 268 AADI
Real-Time Collector Operating Manual
• Switch on the instrument by pressing the power button in the front of the instrument.
• Wait approximately 30 seconds before the instruments starts up and connection is available.
3.3.2 Connected via SmartGuard
• Connect the USB configuration cable between the USB connector on the left hand side of the SmartGuard and
the USB port on your PC
• Install and start the AADI Real-Time Collector software on your PC (provided on the Memory stick delivered
with the instrument if ordered). For more information about the AADI Real-Time Collector, refer TD 268 AADI
Real-Time Collector Operating Manual
• Switch on the logger by turning the power switch to the “ON”- position.
• Wait approximately 30 seconds before the logger starts up and connection is available.
3.3.3 Connected via SeaGuard with plug assembly 5561
• Connect the 0-modem cable between the serial port in front of the instrument and the computer RS-232 port. If
your computer have no serial port you might use a Keyspan USB to serial converter or simmilar.
• Install and start the AADI Real-Time Collector software on your PC (provided on the Memory stick delivered
with the instrument if ordered). For more information about the AADI Real-Time Collector, refer TD 268 AADI
Real-Time Collector Operating Manual
• Switch on the instrument by pressing the power button in the front of the instrument.
• Wait approximately 20 seconds before the instruments starts up and connection is available.