Page 86 February 2020 – TD 266 OPERATING MANUAL – ZPulse® DCS 4420/4830/4520/4930
When all the settings are configured as desired the sensor is ready to
meassure current.
In the Recorder Panel you will find three tabs; Status, Nodes and
Setup
Figure 5-23: Recorder Panel - Status
Under the Setup tab you will find an overview of Timing, Storage and
Communication setting and a button called Recorder Deployment
Settings
Tick the Recording Deployment Settings to enter the deployment
settings menu
Figure 5-24: Recorder Panel - Setup
To Next Page
Loading...