Using TCL Array Plot Section 4 TCL Displays
100 3BUR002418-600 A
• Trace 1 and Trace 2 > Expand to Half Width
Use this to view one half of the trace.
• Trace 1 and Trace 2 > Expand to Quarter Width
Use this to view one fourth of the trace.
• Trace 1 and Trace 2 > Restore
Use this to set the default configuration values. There are separate defaults for
the Plot and Filled Plot displays.
• Ruler
Use this to show the vertical ruler (checked) or not show the ruler.
Number of Points This field is used to specify the number of points to be
plotted.
Number of Points + X-Start Position = X-Axis Width
Specifying more points than available will cause a
diagnostic error message and will not display any
points. Specifying less than 25 points will produce a
low resolution plot (the ruler will offset to the nearest
point during selection).
Y-Axis Top and
Y-Axis Top Bottom
This field is used to specify the top and bottom values
of the y-axis.
X-Axis Width This field is used to specify the width of the x-axis for
the trace in points.
X-Axis Width = Number of Points + X-Start Position
For plot displays, traces #1 and #2 can have different x-
axis widths. Both x-axes will always be spread out
between the y-axes.
X-Start Pos This field is used to specify the point on the x-axis to
start plotting the data pointed to by the respective trace
plot array.
X-Axis Width = Number of Points + X-Start Position
To Next Page
Loading...
