3BUR002418-600 A 121
Section 6 Status Displays
Status Displays Overview
Status displays contain system and subsystem level information that allow you to
identify detectable fault conditions, monitor general status and performance, change
process outputs directly for testing, and control the status of redundancy. The
displays include: System Status, Subsystem Status (AC460, AC410, Controller
Node, Turbo Node), Diagnostic Message, and System Performance. See Section 7,
I/O Displays for: S800 and S100 Device Overview and Status, PROFIBUS, TRIO
and Direct I/O. For additional information on diagnostic displays for the Advant
Controller subsystems, refer to the Advant Controller 410 User’s Guide and/or the
Advant Controller 460 User’s Guide. For all other subsystems, refer to the
appropriate hardware user’s guide user manual.
You are alerted to the presence of a diagnostic message by the Diagnostic Message
List of the base product as described in System 800xA Operations (3BSE036904*).
Entries identifying an operator action on the diagnostic displays are relayed to the
appropriate logging device.
Color coding of data shown on the diagnostic displays, including the labels on the
message targets/buttons, is as follows:
• Red indicates an error.
• Green a good report.
• Yellow a possible problem.
• White a neutral fact.
To Next Page
Loading...
