Appendix A Runtime Templates Temperature Compensation FCM
3BUR002418-600 A 263
COEF THERM EXP Field
This field specifies the value for the coefficient of thermal expansion. Valid entry is
any number.
FLOW COEFFICIENT Field
This field specifies the value for the flow coefficient. Valid entry is any number.
Temperature Compensation FCM
The Temperature Compensation FCM calculates temperature compensated
volumetric and mass flow rates for incompressible fluids.
DES TEMP CONSTANT Field
This field specifies the design temperature constant. Valid entry is any number.
FLOW CONSTANT Field
This field specifies the value of the flow constant. Valid entry is any number.
DEN VS TEMP CONSTANT Field
This field specifies the value of the density versus temperature constant. Valid entry
is any number.
VOLUME OR MASS FLOW? Field
This field specifies whether the FCM uses volumetric flow rate or mass flow rate
algorithm. Valid entries are:
MASS use the mass flow rate algorithm
VOL use the volumetric flow rate algorithm
Ratio/Bias FCM
The Ratio/Bias FCM is used to apply bias and ratio to a signal. Bias and ratio
sources can be local or remote.
To Next Page
Loading...
