Loading a Recipe from the Unit Detail Display Section 4 TCL Displays
82 3BUR002418-600 A
Loading a Recipe from the Unit Detail Display
Note the ID of the recipe you want to download (refer to your Advabuild
documentation). Access the Unit Detail Display of the unit where the recipe is to be
downloaded.
To load a recipe onto a unit,
1. Select the entry field to the right of the Recipe Load Request in the Unit
Detail Display.
2. Type the ID for the desired recipe (optionally, you may load the recipe to a
slave unit by entering, SLAVE after the recipe ID)
3. Press ENTER. The message
Loading Recipe recipe name
is displayed while the system is downloading the recipe.
When downloading is complete, the new Recipe ID is displayed in the Recipe ID
field. You can load one recipe per unit.
Changing Sequence State, Mode, and Status
The sequence state, mode, and status can be changed by selecting one of the
sequences listed on the Unit Detail Display. Use the pull down boxes to make your
selection.
Functions for sequence state are:
For example, to activate an inactive sequence, select ACTIVATE. To end an active
sequence, select ABORT. The abort action causes the TCL sequence to end
immediately without further action by that sequence while the current process
conditions remain unchanged.
ACTIVATE Starts executing steps.
RESUME Starts a paused sequence.
PAUSE Stops a sequence between steps, making it paused.
ABORT Ends a sequence in the middle of a step, making it inactive.
To Next Page
Loading...
