Section 6 Status Displays AC460 Subsystem Status Display
3BUR002418-600 A 129
• HARD RESET
The HA
RD RESET push-button can be used to reset any controller on the AC
460 subsystem display. Resetting a controller through this push-button has the
same effect as depressing the “Enter” button on the controller’s front panel.
This button must not be used during the on-line upgrade procedure.
The following restrictions apply for this command:
– The command is not actually sent until the CONFIRM push-b
utton is
selected.
–The CA
NCEL push-button can be used to clear the fact that this push-
button was selected.
•CONFIRM
Because there is a need to prevent inadv
ertent selection of a push-button from
causing unintended controller resets and switchovers, the CONFIRM push-
button is used to provide a confirmation process for the “RESET for
UPGRADE”, “HARD RESET”, and “SWITCHOVER” functions. The actual
reset or switch request is not sent until the CONFIRM push-button is selected.
• CANCEL
The CANC
EL push-button is used to clear the fact that any other push-button
was selected. You may then Quit or select another command button.
To Next Page
Loading...
