ABB ACS800 Series - Page 162

Fieldbus control
150
Table 4 DataSet 1 Word 3 - Fieldbus Aux Cmd Wd (Actual Signal 06.03)
Bit Name Description
0 DANCER/TENSION
ENABLE
See chapter Actual signals and parameters, parameter 62.09
and 63.09.
1 DANCER/TENSION WEB2
SEL
See chapter Actual signals and parameters, parameter 62.23
and 63.23.
2 MODE TRANSITION
(To Torq)
See chapter Actual signals and parameters, parameter 63.16.
3 DANCER/TENSION ZERO
I-TIME
See chapter Actual signals and parameters, parameter 62.04
and 63.04.
4 CORE SPEED INCREASE See chapter Actual signals and parameters, parameter 61.01.
5 CORE SPEED DECREASE See chapter Actual signals and parameters, parameter 61.01.
6 DIAMETER RESET See chapter Actual signals and parameters, parameter 65.03.
7 DIAMETER RESET See chapter Actual signals and parameters, parameter 65.03.
8 DIAMETER HOLD Holds the current calculated diameter.
9 DIAMETER INCREASE See chapter Actual signals and parameters, parameter 65.12.
10 DIAMETER DECREASE See chapter Actual signals and parameters, parameter 65.13.
11 TORQUE MEMORY
SAMPLE
See chapter Actual signals and parameters, parameter 66.01.
12 TORQUE MEMORY
ENABLE
See chapter Actual signals and parameters, parameter 66.02.
13 TORQUE BOOST ON See chapter Actual signals and parameters, parameter 66.03.
14 WINDING MODE - UNDER See chapter Actual signals and parameters, parameter 60.05.
15 DANCER/TENSION REG
REV
See chapter Actual signals and parameters, parameter 62.08
and 63.08.