ABB ACS880-07CLC

Materials
Hot-dip zinc coated 1.5 mm thick steel sheet (thickness of coating approximately
20 micrometers). Polyester thermosetting powder coating (thickness approximately
80 micrometers) on visible surfaces, color RAL 7035 and RAL 9017.
Cabinet
Tin-plated copperBusbars
See Cooling circuit materials (page 149)
Liquid cooling system
Insulating materials and non-metallic items mostly self-extinctiveFire safety of materials
(IEC 60332-1)
Standard package:Package
• timber, polyethylene sheet (thickness 0.15 mm), stretch film (thickness 0.023 mm),
PP tape, PET strap, sheet metal (steel)
• for land and air transport when planned storage time is less than 2 months or
when storage can be arranged in clean and dry conditions less than 6 months
• can be used when products will not be exposed to corrosive atmosphere during
transport or storage
Container package:
• timber, VCI sheet film (PE, thickness 0.10 mm), VCI stretch film (PE, thickness
0.04 mm), VCI emitter bags, PP tape, PET strap, sheet metal (steel)
• for sea transport in containers
• recommended for land and air transport when storage time prior to installation
exceeds 6 months or storage is arranged in partially weather-protected conditions
Seaworthy package:
• timber, plywood, VCI sheet film (PE, thickness 0.10 mm), VCI stretch film (PE,
thickness 0.04 mm), VCI emitter bags, PP tape, PET strap, sheet metal (steel)
• for sea transport with or without containerization
• for long storage periods in environments where roofed and humidity-controlled
storage cannot be arranged
Cabinets are fastened to the pallet with screws and braced from the top end to the
package walls to prevent swaying inside the package. Package elements are at-
tached to each other with screws.
The main parts of the drive can be recycled to preserve natural resources and en-
ergy. Product parts and materials should be dismantled and separated.
Disposal
Generally all metals, such as steel, aluminum, copper and its alloys, and precious
metals can be recycled as material. Plastics, rubber, cardboard and other packaging
material can be used in energy recovery. Printed circuit boards and large electro-
lytic capacitors need selective treatment according to IEC 62635 guidelines. To aid
recycling, plastic parts are marked with an appropriate identification code.
Contact your local ABB distributor for further information on environmental aspects
and recycling instructions for professional recyclers. End of life treatment must follow
international and local regulations.
Applicable standards
InformationStandard
European electrical safety requirements product standards
Adjustable speed electrical power drive systems. Part 5-1: Safety requirements –
electrical, thermal and energy
IEC/EN 61800-5-1:2007
Semiconductor converters – General requirements and line commutated converters
– Part 1-1: Specification of basic requirements
IEC 60146-1-1:2009
EN 60146-1-1:2010
Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests
IEC/EN 60664-1:2007
Degrees of protection provided by enclosures (IP code).IEC 60529:1989
EN 60529:1991
168 Technical data