PageContentsGroup
367
Settings for the energy saving calculators.
45 Energy efficiency
368
Speed supervision settings; actual signal filtering; general scaling
settings.
46 Monitoring/scaling
settings
372
Data storage parameters that can be written to and read from
using other parameters’ source and target settings.
47 Data storage
375
Communication settings for the control panel port on the drive.
49 Panel port communication
379
Fieldbus communication configuration.
50 Fieldbus adapter (FBA)
388
Fieldbus adapter A configuration.
51 FBA A settings
390
Selection of data to be transferred from drive to fieldbus
controller through fieldbus adapter A.
52 FBA A data in
391
Selection of data to be transferred from fieldbus controller to
drive through fieldbus adapter A.
53 FBA A data out
392
Fieldbus adapter B configuration.
54 FBA B settings
394
Selection of data to be transferred from drive to fieldbus
controller through fieldbus adapter B.
55 FBA B data in
395
Selection of data to be transferred from fieldbus controller to
drive through fieldbus adapter B.
56 FBA B data out
396
Configuration of the embedded fieldbus (EFB) interface.
58 Embedded fieldbus
405
DDCS communication configuration.
60 DDCS communication
423
Defines the data sent to the DDCS link.
61 D2D and DDCS transmit
data
430
Mapping of data received through the DDCS link.
62 D2D and DDCS receive
data
440
Position status and control words.
74 Position status & control
words
450
Definition of motion profiles.
75 Position profile
457
Definition of positioning indexes (tasks).
76 Position indexing
460
Configuration of cyclic position correction function.
78 Cyclic correction
462
Configuration of a generic PI controller for use by the PI sync
correction functionality (see group 87 Master position).
85 PI control
463
Configuration of axis position calculation, homing, and position
limits.
86 Axis position
472
Master position settings and values.
87 Master position
478
Position controller settings and values; position supervision;
position reference settings for master/follower.
88 Position control
484
Motor and load feedback configuration.
90 Feedback selection
489
Configuration of encoder interface modules.
91 Encoder module settings
493
Settings for encoder 1.
92 Encoder 1 configuration
501
Settings for encoder 2.
93 Encoder 2 configuration
504
Control of the supply unit of the drive, such as DC voltage and
reactive power reference.
94 LSU control
507
Various hardware-related settings.
95 HW configuration
132 Parameters
To Next Page
Loading...
