ABB ACS880 N5700 Series

To Next Page

To Previous Page

Def / Type

FbEq 16b / 32b

DescriptionName / Range /

Selection

No.

Language selection; access levels; macro selection;

parameter save and restore; control unit reboot; user

System96

parameter sets; unit selection; data logger triggering;

parameter checksum calculation; user lock.

- / uint16Selects the language of the parameter interface and

other displayed information when viewed on the control

panel.

Language96.1

Note: Not all languages listed below are necessarily

supported.

Note: This parameter does not affect the languages

visible in the Drive Composer PC tool. (Those are

specified under View – Settings.)

1033English.English

0 / uint32Pass codes can be entered into this parameter to

activate further access levels (see parameter 96.3

Access levels active) or to configure the user lock.

Pass code96.2

Entering "358" toggles the parameter lock, which

prevents the changing of all other parameters through

the control panel or the Drive Composer PC tool.

Entering the user pass code (by default, "10000000")

enables parameters 96.100 … 96.102, which can be

used to define a new user pass code and to select the

actions that are to be prevented.

Entering an invalid pass code will close the user lock if

open, i.e. hide parameters 96.100 … 96.102. After

entering the code, check that the parameters are in

fact hidden. If they are not, enter another (random)

pass code.

Entering several invalid pass codes introduces a delay

before a new attempt can be made. Entering further

invalid codes will progressively lengthen the delay.

Note: You must change the default user pass code to

maintain a high level of cybersecurity. Store the code

in a safe place – the protection cannot be disabled even

by ABB if the code is lost.

ABB ACS880 N5700 Series - System