Terms and abbreviations
DefinitionTerm
Type of parameter that is the result of a measurement or calculation by the
drive, or contains status information. Most actual signals are read-only, but
some (especially counter-type actual signals) can be reset.
Actual signal
(In the following table, shown on the same row as the parameter name) The
default value of a parameter when used in the Factory macro. For information
on other macro-specific parameter values, see chapter Application macros.
Def
Note: Certain configurations or optional equipment may require specific de-
fault values.
These are labelled as follows:
(95.20 bx) = Default changed or write-protected by parameter 95.20, bit x.
(In the following table, shown on the same row as the parameter range, or
for each selection)
FbEq
16b / 32b
The scaling between the integer used in communication and the value shown
on the panel when a 16-bit value is selected for transmission to an external
system. The scaling is indicated for both 16-bit and 32-bit values. A dash (-)
indicates that the parameter is not accessible in that format.
The value is taken from another parameter.Other
Choosing “Other” displays a parameter list in which the user can specify the
source parameter.
Note: The source parameter must be of the real32 (32-bit floating point) type.
To use a 16-bit integer (for example, received from an external device in data
sets) as the source, data storage parameters 47.1 … 47.8 can be used.
The value is taken from a specific bit in another parameter.Other [bit]
Choosing “Other” displays a parameter list in which the user can specify the
source parameter and bit.
Either a user-adjustable operating instruction for the drive, or an actual signal.Parameter
Per unitp.u.
The value of the parameter.[parameter
number in
square
brackets]
130 Parameters
To Next Page
Loading...
