Parameter group summary
PageContentsGroup
134
Basic signals for monitoring the drive.
1 Actual values
140
Values of references received from various sources.
3 Input references
142
Information on warnings and faults that occurred last.
4 Warnings and faults
150
Various run-time-type counters and measurements related to
drive maintenance.
5 Diagnostics
152
Drive control and status words.
6 Control and status words
169
Information on drive hardware, firmware and application program.
7 System info
173
Configuration of digital inputs and relay outputs.
10 Standard DI, RO
180
Configuration of digital input/outputs and frequency
inputs/outputs.
11 Standard DIO, FI, FO
186
Configuration of standard analog inputs.
12 Standard AI
192
Configuration of standard analog outputs.
13 Standard AO
198
Configuration of I/O extension module 1.
14 I/O extension module 1
226
Configuration of I/O extension module 2.
15 I/O extension module 2
232
Configuration of I/O extension module 3.
16 I/O extension module 3
238
Selection of local and external control location sources and
operating modes.
19 Operation mode
241
Start/stop/direction and run/start/jog enable signal source
selection; positive/negative reference enable signal source
selection.
20 Start/stop/direction
252
Start and stop modes; emergency stop mode and signal source
selection; DC magnetization settings; autophasing mode
selection.
21 Start/stop mode
263
Speed reference selection; motor potentiometer settings.
22 Speed reference selection
270
Speed reference ramp settings (programming of the acceleration
and deceleration rates for the drive).
23 Speed reference ramp
277
Speed error calculation; speed error window control configuration;
speed error step.
24 Speed reference
conditioning
285
Speed controller settings.
25 Speed control
297
Settings for the frequency reference chain.
26 Torque reference chain
306
Drive operation limits.
30 Limits
316
Configuration of external events; selection of behavior of the
drive upon fault situations.
31 Fault functions
328
Configuration of signal supervision functions 1…3.
32 Supervision
332
Configuration of maintenance timers/counters.
33 Generic timer & counter
340
Motor thermal protection settings such as temperature
measurement configuration, load curve definition and motor fan
control configuration.
35 Motor thermal protection
355
Peak value and amplitude logger settings.
36 Load analyzer
359
Settings for the internal brake chopper.
43 Brake chopper
362
Configuration of mechanical brake control.
44 Mechanical brake control
Parameters 131
To Next Page
Loading...
