8
Fault tracing
What this chapter contains
The chapter lists the warning and fault messages including possible causes and
corrective actions. The causes of most warnings and faults can be identified and
corrected using the information in this chapter. If not, contact an ABB service
representative. If you have the possibility to use the
Drive Composer
PC software,
send the Support package created by the Drive Composer tool to the ABB service
representative.
Warnings and faults are listed below in separate tables. Each table is sorted by
warning/fault code.
Safety
WARNING!
Only qualified electricians are allowed to service the drive. Read the
instructions in the
Safety instructions
chapter of the
Hardware manual
of
the drive before working on the drive.
Indications
￭
Warnings and faults
Warnings and faults indicate an abnormal drive status. The codes and names of
active warnings/faults are displayed on the control panel of the drive as well as
the
Drive Composer
PC tool. Only the codes of warnings/faults are available over
fieldbus.
Fault tracing 547
To Next Page
Loading...
