ABB ACS880 N5700 Series - Standard DIO, FI, FO

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
Configuration of digital input/outputs and frequency
inputs/outputs.
Standard DIO, FI,
FO
11
- / uint16Displays the status of digital input/outputs DIO2 and
DIO1.
DIO status11.1
The activation/deactivation delays (if any are specified)
are ignored. A filtering time (for input mode) can be
defined by parameter 11.81 DIO filter time.
Example: 0010 = DIO2 is on, DIO1 is off.
This parameter is read-only.
- / uint16Displays the delayed status of digital input/outputs
DIO2 and DIO1. This word is updated only after
DIO delayed status11.2
activation/deactivation delays (if any are specified). A
filtering time (for input mode) can be defined by
parameter 11.81 DIO filter time.
Example: 0010 = DIO2 is on, DIO1 is off.
This parameter is read-only.
Output / uint16Selects whether DIO1 is used as a digital output or
input, or a frequency input.
DIO1 function11.5
0DIO1 is used as a digital output.Output
1DIO1 is used as a digital input.Input
2DIO1 is used as a frequency input.Frequency
Ready run / uint32Selects a drive signal to be connected to digital
input/output DIO1 when parameter 11.5 DIO1 function
is set to Output.
DIO1 output source11.6
0Output is not energized.Not energized
1Output is energized.Energized
2Bit 1 of 6.11 Main status word (page 153).Ready run
4Bit 0 of 6.16 Drive status word 1 (page 153).Enabled
5Bit 5 of 6.16 Drive status word 1 (page 153).Started
6Bit 1 of 6.17 Drive status word 2 (page 154).Magnetized
7Bit 6 of 6.16 Drive status word 1 (page 153).Running
8Bit 2 of 6.11 Main status word (page 153).Ready ref
9Bit 8 of 6.11 Main status word (page 153).At setpoint
10Bit 2 of 6.19 Speed control status word (page 155).Reverse
11Bit 0 of 6.19 Speed control status word (page 155).Zero speed
12Bit 10 of 6.17 Drive status word 2 (page 154).Above limit
13Bit 7 of 6.11 Main status word (page 153).Warning
14Bit 3 of 6.11 Main status word (page 153).Fault
15Inverted bit 3 of 6.11 Main status word (page 153).Fault (-1)
16Bit 13 of 6.16 Drive status word 1 (page 153).Start request
22Bit 0 of 44.1 Brake control status (page 362).Open brake
command
23Bit 11 of 6.16 Drive status word 1 (page 153).Ext2 active
180 Parameters