ABB ACS880 N5700 Series - Cyclic Correction

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
Configuration of cyclic position correction function.Cyclic correction78
- / uint16Cyclic correction status word.
This parameter is read only.
Cyclic correction
status
78.1
1 = Cyclic correction function run enable.Enableb0
1 = Correction latched and correction started at least
once
Correction
processed once
b1
Reservedb2…3
1 = Correction calculated and commandedCorrection
command
b4
1 = correction on-going.Correction activeb5
1 = Correction done.Correction doneb6
Reservedb7
1 = Monitoring latch1.Latch1 commandb8
1 = Monitoring latch2.Latch2 commandb9
1 = Latch1 received and ready for correction.Latch1 receivedb10
1 = Latch2 received and ready for correction.Latch2 receivedb11
Reservedb12…15
1 = 10000h…FFFFh
0.000 units / real32Calculates the required cyclic correction value.Cyclic correction
value
78.2
1000 = 1 units / 1 = 1
units
Cyclic correction value.-2000000.000 ...
2000000.000 units
False / int32Selects a source that enables/disables the cyclic
correction function.
Cyclic correction
enable
78.10
00False
11True
2Digital input DI1 (10.2 DI delayed status, bit 0).DI1
3Digital input DI2 (10.2 DI delayed status, bit 1).DI2
4Digital input DI3 (10.2 DI delayed status, bit 2).DI3
5Digital input DI4 (10.2 DI delayed status, bit 3).DI4
6Digital input DI5 (10.2 DI delayed status, bit 4).DI5
7Digital input DI6 (10.2 DI delayed status, bit 5).DI6
8Digital input/output DIO1 (11.2 DIO delayed status, bit
0).
DIO1
9Digital input/output DIO2 (11.2 DIO delayed status, bit
1).
DIO2
10Bit 0 of 74.7 User Position control word 1.User Position CW1
bit 0
11Bit 1 of 74.7 User Position control word 1.User Position CW1
bit 1
460 Parameters