Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
Defines the data sent to the DDCS link.D2D and DDCS
transmit data
61
See also parameter group 60 DDCS communication.
Follower CW / uint32Preselects the data to be sent as word 1 onto the
master/follower link.
M/F data 1 selection61.1
See also parameter 61.25 M/F data 1 value, and section
General (page 66).
0None.None
1Control Word (16 bits)CW 16bit
4Status Word (16 bits)SW 16bit
5Actual value ACT1 (16 bits)
Note: Using this setting to send a reference to the
follower is not recommended as the source signal is
filtered. Use the “reference” selections instead.
Act1 16bit
6Actual value ACT2 (16 bits)
Note: Using this setting to send a reference to the
follower is not recommended as the source signal is
filtered. Use the “reference” selections instead.
Act2 16bit
27A word consisting of bits 0…11 of 6.1 Main control word
and the bits selected by parameters 06.45…06.48.
Follower CW
Note: Bit 3 of the follower control word is kept on as
long as the master is modulating, and when it switches
to 0, the follower coasts to a stop.
614524.1 Used speed reference (page 277).Used speed
reference
673126.75 Torque reference act 5 (page 305).Torque reference act
5
665826.2 Torque reference used (page 297).Torque reference
used
28A follower status word compatible with an ACS800
(System Control Program) master. With this setting,
ACS800 System ctrl
SW
status word bit 0 is cleared whenever the run enable
signal is missing.
29Otherwise identical to selection Follower CW, but bit
6 of the follower control word is also kept on as long
Follower CW B6 high
as the master is modulating. This will allow the follower
to stop along the stop ramp of the master.
80901332-bit position value as displayed by 88.53 D2D position
send.
Note: This setting cannot be used in 61.03 M/F data 3
selection because the 32-bit value requires two
consecutive words.
D2D position
Parameters 423
To Next Page
Loading...
