Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
22582Scaled velocity value as displayed by 88.54 D2D velocity
send.
Note: Occasionally, below data are also sent to the
follower:
• 32768-Position initialization or position send type
changed.
• 32767-Latch 1 triggered in master.
D2D velocity
See Terms and abbreviations (page 130).Other [value]
Used speed reference
/ uint32
Preselects the data to be sent as word 2 onto the
master/follower link.
See also parameter 61.26 M/F data 2 value.
For the selections, see parameter 61.1 M/F data 1
selection.
M/F data 2 selection61.2
0This is the block, where writer describes in more details
how the selection value should be interpreted.
None
1This is the block, where writer describes in more details
how the selection value should be interpreted.
CW 16bit
4This is the block, where writer describes in more details
how the selection value should be interpreted.
SW 16bit
5This is the block, where writer describes in more details
how the selection value should be interpreted.
Act1 16bit
6This is the block, where writer describes in more details
how the selection value should be interpreted.
Act2 16bit
27This is the block, where writer describes in more details
how the selection value should be interpreted.
Follower CW
6145This is the block, where writer describes in more details
how the selection value should be interpreted.
Used speed
reference
6731This is the block, where writer describes in more details
how the selection value should be interpreted.
Torque reference act
5
6658This is the block, where writer describes in more details
how the selection value should be interpreted.
Torque reference
used
28This is the block, where writer describes in more details
how the selection value should be interpreted.
ACS800 System ctrl
SW
29This is the block, where writer describes in more details
how the selection value should be interpreted.
Follower CW B6 high
Torque reference act
5 / uint32
Preselects the data to be sent as word 3 onto the
master/follower link.
See also parameter 61.27 M/F data 3 value.
For the selections, see parameter 61.1 M/F data 1
selection.
M/F data 3 selection61.3
- / uint16Displays the data to be sent onto the master/follower
link as word 1 as an integer.
If no data has been preselected by 61.1 M/F data 1
selection, the value to be sent can be written directly
into this parameter.
M/F data 1 value61.25
424 Parameters
To Next Page
Loading...
