ABB ACS880 N5700 Series - Page 425

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
- / -Data to be sent as word 1 in master/follower
communication.
0...65535
- / uint16Displays the data to be sent onto the master/follower
link as word 2 as an integer.
If no data has been preselected by 61.2 M/F data 2
selection, the value to be sent can be written directly
into this parameter.
M/F data 2 value61.26
- / -Data to be sent as word 2 in master/follower
communication.
0...65535
- / uint16Displays the data to be sent onto the master/follower
link as word 3 as an integer.
If no data has been preselected by 61.3 M/F data 3
selection, the value to be sent can be written directly
into this parameter.
M/F data 3 value61.27
- / -Data to be sent as word 3 in master/follower
communication.
0...65535
None / uint32Parameters 61.45…61.50 preselect data to be sent in
data sets 2 and 4 to the external controller. These data
sets are used in ModuleBus communication with a
“standard drive” (60.50 DDCS controller drive type =
ABB standard drive). Parameters 61.95…61.100 display
the data to be sent to the external controller. If no data
has been preselected, the value to be sent can be
written directly into these parameters. For example,
this parameter preselects the data for word 1 of data
set 2. Parameter 61.95 Data set 2 data 1 value displays
the selected data in integer format. If no data is
preselected, the value to be sent can be written directly
into parameter 61.95.
Data set 2 data 1
selection
61.45
0None.None
1Control Word (16 bits)CW 16bit
4Status Word (16 bits)SW 16bit
5Actual value ACT1 (16 bits)Act1 16bit
6Actual value ACT2 (16 bits)Act2 16bit
See Terms and abbreviations (page 130).Other [value]
None / uint32Preselects the data to be sent as word 2 of data set 2
to the external controller.
See also parameter 61.96 Data set 2 data 2 value.
For the selections, see parameter 61.45 Data set 2 data
1 selection.
Data set 2 data 2
selection
61.46
None / uint32See parameter 61.45 Data set 2 data 1 selection.Data set 2 data 3
selection
61.47
…………
None / uint32See parameter 61.45 Data set 2 data 1 selection.Data set 4 data 3
selection
61.50
Parameters 425