ABB ACSM1 - Page 102

Parameters and firmware blocks
102
3.15 BRAKE COMMAND FW block: MECH BRAKE CTRL (page 186)
Brake on/off command. 0 = Close. 1 = Open. For brake on/off control, connect this signal to a relay
output (or a digital output). See section Mechanical brake control on page 55.
3.16 FLUX REF USED FW block: MOTOR CONTROL (page 189)
Used flux reference in percent.
3.17 TORQUE REF USED FW block: MOTOR CONTROL (page 189)
Used/limited torque reference in percent.
3.20 MAX SPEED REF FW block: LIMITS (page 145)
Maximum speed reference.
3.21 MIN SPEED REF FW block: LIMITS (page 145)
Minimum speed reference.