Introduction to the manual
14
Contents
The manual consists of the following chapters:
• Start-up instructs in setting up the control program and how to control the drive
through the I/O interface.
• Drive programming using PC tools introduces programming via PC tool
(DriveStudio and/or DriveSPC).
• Drive control and features describes the control locations and operation modes of
the drive, and the features of the application program.
• Default connections of the control unit presents the default connections of the
JCU Control Unit.
• Parameters and firmware blocks describes the drive parameters and firmware
function blocks.
• Parameter data contains more information on the parameters of the drive.
• Fault tracing lists the warning and fault messages with the possible causes and
remedies.
• Standard function blocks
• Application program template
• Appendix A – Fieldbus control describes the communication between the drive
and a fieldbus.
• Appendix B – Drive-to-drive link describes the communication between drives
connected together by the drive-to-drive link.
• Appendix C – Homing methods describes homing methods 1…35.
• Appendix D – Application examples.
• Appendix E – Control chain and drive logic diagrams.
Product and service inquiries
Address any inquiries about the product to your local ABB representative, quoting
the type code and serial number of the unit in question. A listing of ABB sales,
support and service contacts can be found by navigating to www.abb.com/drives
and
selecting Drives – Sales, Support and Service network.
Product training
For information on ABB product training, navigate to www.abb.com/drives and select
Drives – Training courses.
Providing feedback on ABB Drives manuals
Your comments on our manuals are welcome. Go to www.abb.com/drives and select
Document Library – Manuals feedback form (LV AC drives).
To Next Page
Loading...
