ABB ACSM1 - Group 17 PANEL DISPLAY

Parameters and firmware blocks
143
Group 17 PANEL DISPLAY
Selection of signals for panel display.
17
17.01 SIGNAL1 PARAM FW block: None
Selects the first signal to be displayed on the control panel. The default signal is 1.03 FREQUENCY.
Value pointer: Group and index
17.02 SIGNAL2 PARAM FW block: None
Selects the second signal to be displayed on the control panel. The default signal is 1.04 CURRENT.
Value pointer: Group and index
17.03 SIGNAL3 PARAM FW block: None
Selects the third signal to be displayed on the control panel. The default signal is 1.06 TORQUE.
Value pointer: Group and index
17.04 SIGNAL1 MODE FW block: None
Defines the way the signal selected by parameter 17.01 SIGNAL1 PARAM is displayed on the
optional control panel.
(-1) Disabled Signal not displayed. Any other signals that are not disabled are
shown together with their respective signal name.
(0) Normal Shows the signal as a numerical value followed by unit.
(1) Bar Shows the signal as a horizontal bar.
(2) Drive name Shows the drive name. (The drive name can be set using the
DriveStudio PC tool.)
(3) Drive type Shows the drive type.
17.05 SIGNAL2 MODE FW block: None
Defines the way the signal selected by parameter 17.01 SIGNAL1 PARAM is displayed on the
optional control panel.
(-1) Disabled Signal not displayed. Any other signals that are not disabled are
shown together with their respective signal name.
(0) Normal Shows the signal as a numerical value followed by unit.
(1) Bar Shows the signal as a horizontal bar.
(2) Drive name Shows the drive name. (The drive name can be set using the
DriveStudio PC tool.)
(3) Drive type Shows the drive type.