Parameters and firmware blocks
144
17.06 SIGNAL3 MODE FW block: None
Defines the way the signal selected by parameter 17.01 SIGNAL1 PARAM is displayed on the
optional control panel.
(-1) Disabled Signal not displayed. Any other signals that are not disabled are
shown together with their respective signal name.
(0) Normal Shows the signal as a numerical value followed by unit.
(1) Bar Shows the signal as a horizontal bar.
(2) Drive name Shows the drive name. (The drive name can be set using the
DriveStudio PC tool.)
(3) Drive type Shows the drive type.
To Next Page
Loading...
