Parameters and firmware blocks
205
Group 50 FIELDBUS
Basic settings for fieldbus communication. See also Appendix A – Fieldbus control
on page 423.
50
Firmware block:
FIELDBUS
(50)
This block
• initialises the fieldbus
communication
• selects communication supervision
method
• defines scaling of the fieldbus
references and actual values
• selects sources for programmable
status word bits
• shows the fieldbus control and
status words, and references.
Block outputs located in other
parameter groups
2.12 FBA MAIN CW (page 95)
2.13 FBA MAIN SW (page 98)
2.14 FBA MAIN REF1 (page 99)
2.15 FBA MAIN REF2 (page 99)
50.01 FBA ENABLE FW block: FIELDBUS (see above)
Enables communication between the drive and fieldbus adapter.
(0) Disable No communication.
(1) Enable Communication between drive and fieldbus adapter enabled.
50.02 COMM LOSS FUNC FW block: FIELDBUS (see above)
Selects how the drive reacts upon a fieldbus communication break. The time delay is defined by
parameter 50.03 COMM LOSS T OUT.
(0) No Communication break detection disabled.
(1) Fault Communication break detection active. Upon a communication break,
the drive trips on fault FIELDBUS COMM and coasts to stop.
(2) Spd ref Safe Communication break detection active. Upon a communication break,
the drive generates alarm FIELDBUS COMM and sets the speed to
the value defined by parameter 46.02 SPEED REF SAFE.
WARNING! Make sure that it is safe to continue operation in
case of a communication break.
FIELDBUS
36
MISC_2 500 µsec (1)
50.01 FBA ENABLE
(Dri ve value)
50.02 COMM LOSS FUNC
(Dri ve value)
50.03 COMM LOSS T OUT
(Dri ve value)
50.04 FBA REF1 MODESEL
(Dri ve value)
50.05 FBA REF2 MODESEL
(Dri ve value)
< 50.06 FBA ACT1 TR SRC
[ SPEED ACT ]
(7 / 1.01)
< 50.07 FBA ACT2 TR SRC
[ TORQUE ]
(1 / 1.06)
< 50.08 FBA SW B12 SRC
(Dri ve value)
< 50.09 FBA SW B13 SRC
(Dri ve value)
< 50.10 FBA SW B14 SRC
(Dri ve value)
< 50.11 FBA SW B15 SRC
(Dri ve value)
50.12 FBA CYCLE TIME
(Dri ve value)
50 .20 FB MAIN SW FUNC
(Dri ve value)
2.12 FBA MAIN CW
2.13 FBA MAIN SW
2.14 FBA MAIN REF1
2.15 FBA MAIN REF2
To Next Page
Loading...
