ABB ACSM1 - Page 93

Parameters and firmware blocks
93
1.27 RUN TIME COUNTER FW block: ACTUAL VALUES (see above)
Motor run time counter. The counter run when the drive modulates. The counter can be reset using
the DriveStudio tool.
1.28 FAN ON-TIME FW block: ACTUAL VALUES (see above)
Running time of the drive cooling fan. Can be reset by entering 0.
1.31 MECH TIME CONST FW block: ACTUAL VALUES (see above)
Mechanical time constant of the drive and the machinery as determined by the speed controller
autotune function. See parameter 28.16 PI TUNE MODE on page 173.
1.38 TEMP INT BOARD FW block: ACTUAL VALUES (see above)
Measured temperature of the interface board in degrees Celsius.
1.39 OUTPUT VOLTAGE FW block: None
Calculated motor voltage.
1.42 FAN START COUNT FW block: None
Number of times the drive cooling fan has been started.