ABB Advant Controller 450 - S100 I;O with Object Oriented Connection Units

Advant
®
Controller 450 User’s Guide
Section 2.1.4 Standard Layout and Disposition of Cabinets
3BSE 002 415R701 Rev A 2-7
S100 I/O with Object Oriented Connection Units
A variant of cabinet configuration is offered for this type of connection units. See illustrations in
Figure 2-3.
• Normal start configuration is a double cabinet for the connection units and a single cabinet
for the I/O subrack. Split delivery is possible.
You can obtain information about deviations from these rules upon request.
Figure 2-3. S100 I/O with Object Oriented Connection Units (Example of Cabinet
Configuration)
PS
I/O 1
SW
Mains
PS
I/O 1
I/O 2
SW
Mains
PS
I/O 1
I/O 2
SW
Mains
PS
I/O 3
SW
Mains
Opto
El. alt.
Bus Extension,
Ex., 1 subrack
Ex., 2 subrack
Ex., 3 subrack
Conn.
units
PS Power Supply
SW Power Switch
Opto
El. alt.
Bus Extension,
Opto
El. alt.
Bus Extension,