ABB Advant Controller 450 User Manual

Advant
®
Controller 450 User’s Guide
Section 2.1.13 Transportation and Storing
3BSE 002 415R701 Rev A 2-15
The free space in front of the cabinet should be the width of the door plus the width of the aisle.
If a double door alternative is used, reflect the space required for any hinged frame. There must
always be space left for safety reasons even with open doors or frames bent outwards.
For dimensions of the RM500 cabinet type, see Appendix B, RM500 Cabinet - Data Sheet.
You can also find the estimated weight of a cabinet in that section.
2.1.13 Transportation and Storing
Cabinets are packed in a manner appropriate to the means of transport. A pallet is commonly
used, so a fork-lift truck or a hand truck is usually the most suitable means of transport on site.
Cabinets are fitted with lifting eyes to facilitate transport with a crane.
NOTE
Please, observe lifting instructions enclosed with the cabinet!
Store cabinets in a dry place, protected against dust.
2.2 Setup
The goal of this section is to tell you “how to” set up the product.
Follow the sequence of activities prior to power-up described below.
It is assumed that the equipment is assembled and delivered in type RM500 cabinets. If you are
using other types of cabinets, see separate documentation regarding questions such as proper
levelling and how to screw cabinets together.
The equipment to be set up is ordered for and adapted to a specific application. When process
I/O Series 100 is used, the delivery is normally comprised of several cabinets (single or double)
which are to be placed side by side.
Apply the setup instructions with respect to the specific design!
See Section 2.2.1, Safety Regulations through Section 2.2.7, Power Supply Connection for
general information, followed by individual setup descriptions for different parts of the
automation system. You can find this information under the following headings, if relevant:
• Assembly
• Electric Installation (including Power Supply)
• Functional Measures
• Preparation for Start-up.
Ordinary installation drawings, terminal diagram forms and connection documents for site
preparation and installation of electrical equipment also apply.
Necessary Outfit
The following kit is a minimum requirement:
• Ordinary hand tools.
• Universal instrument, for example digital multimeter.
• Test leads with 4 mm banana contacts and reducer contacts for a 2 mm test jack.
• Necessary parts of the documentation listed in Section 1.4, Related Documentation.

ABB Advant Controller 450 Specifications

General

Brand	ABB
Model	Advant Controller 450
Category	Controller
Language	English