ABB Advant Controller 450 User Manual

Advant
®
Controller 450 User’s Guide
Section 4.1.7 Programmed Start
3BSE 002 415R701 Rev A 4-11
4.1.7 Programmed Start
In Advant Controller 450, you can determine how the process control is to start up and how the
system is to start after a mains voltage failure.
You can make these determinations with parameters in a data base element (START) and with a
PC program for programmed start-up. In the PC program, you can define how the process is to
start (by controlling the inputs on the execution units which control the process). Start module
and time limits and start method for the restart alternative are defined in the data base element.
For a detailed description of the start-up function, see the reference manual AMPL
Configuration Advant Controller 400 Series.
A redundant processor module does not complicate the application and the operation.
The information given in the previous sections are applied.
See the overview of the start functions below.
Figure 4-7 is an overview of programmed start at power-fail - power-up.
Figure 4-8 describes programmed start at AUTO - ENTER (when you push the ENTER button
while the start mode selector on the processor module front is in the AUTO position).
Figure 4-9 describes programmed start at DICONFIG.

ABB Advant Controller 450 Specifications

General

Brand	ABB
Model	Advant Controller 450
Category	Controller
Language	English