ABB Advant Controller 450 User Manual

Advant
®
Controller 450 User’s Guide
Section I.3 List of System Messages and Corrective Actions
3BSE 002 415R701 Rev A I-3
I.3 List of System Messages and Corrective Actions
In the following listing those messages which are of particular interest to an end user are
included. These can be easily corrected by the user himself.
System messages not described here shall be noted and forwarded to ABB to determine if any
action is necessary.
Further fault finding and user repair is described in chapter 5 Maintenance.
DANGER
You should carefully follow general safety instructions given in Chapter 5,
Maintenance when fault finding and operating an Advant Controller system
to minimize the risk of injury to personnel and damage to the equipment.
NOTE
In all situations when the controller has stopped you should carefully read all
halt codes and system messages available before you proceed. See Section
5.4.2.1, Reading of System Messages.
Table I-3. Type 2, Code 46
Type Code Significance Task Comments/Actions
2 46 Overload CXKK220 The system is overloaded on a low priority
Table I-4. Type 5, Code 21
Type Code Significance Task Comments/Actions
5 21 Task interrupted CXAF000 for
EXCOM 1
CXAF000 for
EXCOM 2
This message occurs before restart of EXCOM
tasks.
11 1 12:16:30 2 46 CXKK220
Type 2 Overload
11 1 12:15:31 5 21 CXAF000 H’00005982
Type 5 Task interrupted
A H’00000004
H’00000000

ABB Advant Controller 450 Specifications

General

Brand	ABB
Model	Advant Controller 450
Category	Controller
Language	English