ABB Advant Controller 450 User Manual

Advant
®
Controller 450 User’s Guide
Chapter 5 Maintenance
5-22 3BSE 002 415R701 Rev A
S100 I/O 1
Figure 5-3. System Status Display, S100 I/O 1
Stat Act Name
Stat Act Name
1
AI1
AI2
AI3
AO1
AO2
DI1 DO1
Stat Act Name
Stat Act Name
Reference in S100 I/O 1 Display:
Presentation:
Function :
Actions at fault :
Block Diagram:
User defined name
green Normal
red cr Fault - the board is erroneous
Status information for an S100 I/O board
1. If stat indicates erroneous, the board should be replaced
Plain System Message
at fault :
1
(default: DB item designation for
Stat
(Status)
the board)
green The board is in service
yellow cr Theboard is out of service
Act
(Activated)
2. If the board is out of service, see respective data base item, terminal SERVICE
Software
DB; XX-board
System status
Hardware
ERR
1/0
IMPL
DIAGN.
XX board
NAME
Stat
Act
´Name´
SERVICE
1/0
Oper. stn.
dialog
S100 I/O bus extension HW
´Name´
PROC I/O ST
XX Board error Net xx Nod yy
See Section 5.4.10.1, Board and Subrack Mounted Unit Exchange

ABB Advant Controller 450 Specifications

General

Brand	ABB
Model	Advant Controller 450
Category	Controller
Language	English